Manual hydraulic pump safety operation guide

I. Introduction

Manual hydraulic pump

1. The safety of manual hydraulic pump operators is the most important aspect of product design. In addition to operating instructions, manual hydraulic pump operators should also comply with general laws and regulations and related accident prevention regulations and environmental protection rules.

2. Manual hydraulic pump operators only allow employees who have been properly trained in equipment safety to operate, otherwise there is a danger of industrial accidents.

3 , manual hydraulic pump operators should carefully read the operating instructions and fully comply with the guideline requirements before operation.

4. China Rescue Equipment Network recommends inviting a professional manual hydraulic pump operator to train employees to use this equipment.

Second, the safe operation guide

Before operating the manual hydraulic pump, you must read through the following safety instructions.

1. Ensure that the accessories and connected equipment to be used can withstand the maximum pressure during operation.

2. The guarantor's limb or clothing must not be stuck on the moving parts.

3 , wear protective clothing, safety helmets with protective masks, safety boots and protective gloves.

4 , prohibit hydraulic equipment overload operation. If such operations must be performed, they must be completed using auxiliary machinery.

5 , failure, immediately turn off the equipment for repair. Repair the fault immediately.

6. Observe the operating rules in the Safety and Dangerous Operations Guide for all equipment.

7. Ensure that the site meets all safety requirements of the equipment reasonably and fully.

8 , to ensure long-term safety equipment.

9. Before starting the equipment and during operation, it must be ensured that no one will damage the equipment.

10. When the work is close to parts and cables for work, corresponding measures shall be taken to prevent current and high voltage from being transmitted to the equipment.

11. Avoid electrostatic discharge and spark formation when handling equipment.

12 , motor pump can not be used in the explosive area.

13. If the internal combustion engine fuel leaks, clean spilled fuel must be clearly understood before starting the internal combustion engine.

14. Make sure that the internal combustion engine and its fuel are kept away from the fuel source, otherwise it will cause an explosion.

15. When using the internal combustion engine, avoid the occurrence of fire, ensure adequate ventilation, and at least a one meter safety distance from walls and other shelters.

16. Ensure that the internal combustion engine pump is placed horizontally to prevent fuel leakage.

17. This device is full of liquid. If swallowing liquids or inhaling the released gases, it will be harmful to human health. Therefore, direct skin contact should also be avoided. Note that this liquid also has a negative effect on biological systems.

18 , to ensure adequate lighting during work.

19. When using the equipment, ensure that the operating instructions are used with it.

20. In addition to the operating guides, it is also necessary to comply with national and international general laws and regulations and related accident prevention regulations and environmental protection rules!

Third, the correct use of methods

1. Pay attention to product parameter restrictions on operating pressure, load limits, and operating conditions. The operating pressure cannot be higher than the maximum operating pressure of the system components.

2. The operating pressure must not exceed the pressure set in the "Technical Data" section. Higher values ​​may result in equipment damage.

3 , to ensure that the hand pump capacity is sufficient to operate the connected hydraulic cylinders and equipment. The required hydraulic flow can be found in chapter "Technical data" or in the operating manual of the connected device.

This article was originally created by China Rescue Equipment Network. Please indicate the link.